Dot gain is the difference between the dot area on the plate and the dot area that ends up on the sheet. Part of that gap belongs to the press, part belongs to the ink, and a large part belongs to the paper. Before a job is priced, the stock has to be chosen with that in mind, because a sheet that spreads ink too readily will fill in the shadows and dull the highlights no matter how carefully the press is set.
Ink Acceptance and Absorbency
Printability of a sheet starts at its surface. A paper that accepts ink quickly pulls the vehicle away from the pigment, and the pigment spreads farther than the halftone dot intended. Absorbency describes how fast and in what quantity ink penetrates the sheet. The higher the absorbency, the higher the dot gain percentage tends to be. When ink sets on an absorbent sheet, penetration and lateral spreading happen together, and the measured dot grows.
Absorption speed matters more than total pore volume. Two sheets can hold the same amount of ink and still behave differently if one takes it in during the first seconds after impression while the other holds the film on the surface longer.
Smoothness Against the Ideal Plane
Smoothness measures how far the real surface departs from a perfect plane. The relation to dot gain is direct: a smoother sheet gives smaller dot gain, a rougher sheet gives larger dot gain. On a rough surface the ink film has to bridge the valleys, and pressure pushes it sideways into the low spots, which widens the printed dot. A lightly calendered sheet can look right on a proofing press and still fill in on a long run for this reason.
Coated and Uncoated Stocks
Coated papers come in gloss and matte finishes, and both hold detail better than uncoated sheets because their absorbency is lower. The coating acts as a seal: ink stays close to the surface, the dot keeps its shape, and highlights remain open. Lower absorbency means less lateral wicking and a smaller measured gain.
Uncoated paper is highly absorbent. Printing a fine screen on it pushes the gain percentage up sharply, and a file that looks correct on coated stock will look muddy on the uncoated sheet. When a job calls for uncoated, the screen ruling usually has to come down and the shadow end has to be opened in the separations before plating.
Optical Gain at the Ink Edge
A second mechanism has nothing to do with ink spreading. Paper scatters light. When white light strikes bare white paper, roughly 80 percent is reflected. At the boundary between an inked dot and the surrounding sheet, only about 10 percent comes back. The eye reads that darker halo as part of the dot, so the dot appears larger than it measures under a densitometer. The physical dot has not changed; the perceived one has.
This optical component is stronger on bright, highly opaque sheets and weaker on stocks with lower reflectance. It also explains why visual judgment and instrument readings drift apart on coated grades.
Setting the Job Up Around the Sheet
Practical control starts with a decision made before plates are imaged. Ask for the absorbency and smoothness figures of the exact stock, not the grade family. Run a test form on the actual paper at the actual press speed, then measure gain at 50 percent and in the shadow quarter. Build the compensation curve from those readings.
Keep the stock consistent between proof and run. A supplier change, even inside the same nominal grade, can shift absorption and move the gain by several points. Record the mill, the batch and the finish on the job ticket so a reprint can be matched later.
When the paper is chosen for its surface behavior rather than its price per sheet, dot gain becomes a known quantity instead of a surprise found on the delivery pile.